Quantity
|
Out of stock
|
||
|
Wireless GSM alarm system kit ATIS Kit-GSM100 with 99 wireless and 2 wired zones + wireless smoke detector ATIS-229DW.
Brand: ATIS.
The alarm control panel is equipped with a GSM module, which allows for instant voice calls (6 phone numbers), sending out "help" signal (3 phone numbers) and sending out sms messages (3 phone numbers) to mobile phones in case of alarm.
Setting (unsetting) the alarm and its programming can be performed by using a remote control keyfob or mobile phone.
The kit includes:
- control panel;
- wireless PIR motion detector ATIS-804DW;
- wireless door/window sensor ATIS-19DW;
- wired siren;
- wireless smoke detector ATIS-229DW;
- remote control keyfob WBK-404C - 2 pcs;
- power supply unit.
WHERE IS ATIS Kit-GSM100 USED
Thanks to the wide range of sensors included in the supply kit (motion sensor, door opening sensor, smoke sensor, siren), the GSM alarm system ATIS Kit-GSM100 “out of the box” is ready to provide effective protection for apartments, cottages, country houses, garages, or offices.
ADVANTAGES OF ATIS Kit-GSM100
- LCD screen with time indication;
- 2 wired zones, 99 wireless zones can be set in instant, 24-hour, delayed setting mode, partial protection mode, scheduled setting mode, remote setting mode;
- 3 groups of setting and disarming the alarm on a schedule;
- 6 phone numbers for emergency voice calls from the center and 3 numbers for SMS notifications;
- using a mobile phone (DTMF commands or SMS messages) for central programming and remote control;
- intelligent programming system for wireless sensors, fully compatible with PT2262 standard;
- pre-recorded voice messages for accurate identification of sensor activation type, as well as the ability to record your own message on 10 wireless zones;
- using mobile communication for arming/disarming and alarm settings;
- built-in lithium battery ensures uninterrupted device operation in case of power failure (if there is no permanent power supply, the system will notify via SMS message).
ATIS Kit-GSM100 operation principle
By programming and placing wireless and wired sensors from the kit, set up the GSM alarm using a remote control or mobile phone.
In case one of the sensors is triggered (depending on the system settings), the central unit will sequentially call the phone numbers programmed to receive alarm calls and send SMS notifications to the recipients of alarm messages.
Upon receiving an incoming call from the GSM central, a previously recorded voice message about the event will be played, and a list of possible remote actions will be offered:
- arm/disarm the system;
- enable voice message transmission (activate the central unit's speaker);
- disable further calls and SMS transmission to other subscribers.