ATIS Kit GSM+WiFi 130T wireless alarm system kit with Tuya Smart app support.

The wireless GSM and Wi-Fi alarm system ATIS Kit GSM+WiFi 130T has 45 wireless zones and supports up to 8 remote controls, with mobile app support for Tuya Smart.

Brand: ATIS.

The alarm control panel is equipped with a GSM module, allowing for instant voice calls (6 dialing numbers) and SMS messages (3 numbers) to be sent to a mobile phone in case of an alarm, and with the built-in Wi-Fi module, notifications are sent to a smartphone with the Tuya Smart mobile app installed.

The alarm can be set (or disarmed) and programmed using a remote control (included in the package), a mobile phone (SMS/DTMF/Tuya Smart mobile app), or the control panel's keyboard.

The package includes:

1. Control panel
2. PIR motion sensor ATIS-804DW
3. Magnetic contact sensor ATIS-19DW
4. Wired siren
5. Remote control ATIS-8W
6. Power supply unit

Where is ATIS KIT GSM+WiFi 130T Used?

Thanks to the wide range of sensors and additional equipment that comes with the supply kit (motion sensor, door opening sensor, siren, etc.), the wireless alarm system ATIS Kit GSM+WiFi 130 “out of the box” is ready to provide effective security for an apartment, cottage, country house, garage, or office.

Functional Features of ATIS Kit GSM+WiFi 130T

• 45 wireless zones can be set in modes of Arm Effective, Arm/Home Effective, 24-hour (24 Effective Hours), Bypass, Doorbell, Elderly zone, Welcome zone;
• maximum number of connected devices - 45;
• working frequency 433 MHz, Ademco control ID radio communication protocol;
• 2.4-inch TFT screen in the central unit for ease of use;
• support for the mobile application Tuya Smart to control the alarm system;
• 2 groups of arming and disarming the alarm system on schedule;
• 6 phone numbers for emergency voice calls from the central unit and 3 numbers for SMS notifications;
• use of mobile phone (DTMF commands or SMS messages) for programming and remote control of the central unit;
• possibility to record a 10-second voice message;
• use of mobile communication for arming/disarming and alarm system settings;
• built-in lithium battery provides uninterrupted operation of the device in case of power outage (if there is no constant power supply, the system will notify via SMS message).

For Proper Operation

For proper operation, the temperature range should not exceed -10°..+50°C, and the air humidity should not exceed 85%.

Operating Principle of ATIS KIT GSM+WiFi 130T

By programming and installing wireless sensors from the kit, set up the GSM alarm using a keyboard, remote control, or mobile phone.

If one of the sensors triggers (depending on the system settings), the Central will start a sequential dialing to the phone numbers programmed to receive alarm calls, and also send SMS messages to the recipients of alarm messages.

When receiving an incoming call from the GSM central, a previously recorded voice message about the event will be played, and a list of possible remote actions will be offered:

• arm/disarm the system
• activate voice message transmission (turn on the central speaker)
• disable further dialing and SMS transmission to other subscribers

Installation of the ATIS Kit GSM+WiFi 130T

Thanks to the detailed instruction, installation and programming of the alarm system kit ATIS Kit GSM+WiFi 130T will not take much time even for non-specialists.

After installing the central panel, sensors should be installed in their target locations at an equal distance from the central panel.

The central panel programming is performed using DTMF commands and/or SMS messages, as well as through a smartphone using the mobile application Tuya Smart.